New nanoscale electrode design could unlock lighter, longer-range EV batteries

South Korean researchers have developed a nanoscale electrode design that could help make electric-vehicle batteries smaller and lighter while extending their operating life. The technology uses semiconductor manufacturing techniques to address uneven lithium deposition, a major obstacle facing anode-free batteries. Anode-free batteries could potentially increase the amount of energy stored within a given battery size. However, their commercial development has been limited by unstable lithium deposits that reduce performance during repeated charging and discharging. Removing the conventional anode Standard lithium-ion batteries contain an anode material, typically graphite, that stores lithium while the battery charges. Anode-free designs remove this material and instead deposit lithium directly onto a thin copper current collector. Eliminating graphite frees up space and reduces weight, potentially allowing manufacturers to build batteries with higher energy density. For electric vehicles, that could translate into lighter battery packs or greater driving range without increasing pack size. The design also creates a difficult engineering problem. Lithium does not always spread evenly across flat copper foil. Instead, it can accumulate in particular areas and develop into sharp, branching structures called dendrites. These formations destabilize the protective layer surrounding the lithium and encourage unwanted reactions with the electrolyte. Battery performance consequently declines rapidly over repeated cycles. Earlier attempts to solve the problem have included adding surplus lithium or placing thick protective coatings on the electrode. Although these measures can offset lithium losses or shield its surface, they also increase battery weight and volume. Microscopic tubes guide lithium deposition The KAIST-led team modified the copper foil itself using secondary sputtering lithography, or SSL, a precision fabrication method associated with semiconductor manufacturing. Researchers created regularly spaced, tube-shaped structures measuring approximately 300 nanometers across and 150 nanometers high. The arrangement provides defined sites where lithium can settle, helping it spread across the electrode rather than accumulating in isolated areas. The microscopic structures increased the surface area available for lithium deposition to around four times that of untreated flat copper foil. This larger deposition area helped limit the concentrated lithium growth that can produce dendrites. The researchers compared the arrangement to marking closely spaced parking spaces across an otherwise open lot. Each structure helps direct the incoming lithium toward an available location. Ultrathin layer forms stronger protection The team also coated the structured copper foil with an MXene layer roughly 10 nanometers thick. MXenes are two-dimensional materials with surface properties that can be tailored for electrochemical applications. Instead of functioning as the final protective barrier, the coating behaves like a primer. In the study’s LiPF6-based electrolyte, its surface encouraged the development of a uniform protective layer rich in lithium fluoride. That layer reduced unwanted reactions between lithium and the electrolyte while further suppressing dendrite growth. The researchers examined its composition and formation using techniques including X-ray photoelectron spectroscopy, time-of-flight secondary ion mass spectrometry and transmission electron microscopy. “This study shows how ultrafine fabrication techniques used in semiconductor manufacturing can create both uniform sites for lithium deposition and a stable protective layer without changing the bulk electrolyte formulation or adding excess lithium,” Professor Jinwoo Lee said. The research findings were published online in Advanced Functional Materials on September 1. Get the latest in engineering, tech, space & science - delivered daily to your inbox.Atharva is a full-time content writer with a post-graduate degree in media & amp; entertainment and a graduate degree in electronics & telecommunications. He has written in the sports and technology domains respectively. In his leisure time, Atharva loves learning about digital marketing and watching soccer matches. His main goal behind joining Interesting Engineering is to learn more about how the recent technological advancements are helping human beings on both societal and individual levels in their daily lives.